01
Inspection and Moisture Mapping
We start with a thermal imaging camera and moisture meter sweep of the affected area, plus a boroscope inspection camera into wall cavities and duct runs. This takes 45 to 90 minutes and tells us where the moisture is coming from. If we find an active leak, we flag it before any fogging begins.
02
Containment and Air Scrubbing
We seal doorways and vents with containment plastic sheeting and zipper doors, then run a negative air machine with HEPA filters. This keeps spores from drifting into clean rooms during the work. Setup usually takes 30 to 60 minutes depending on the size of the space.
03
HEPA Vacuum and Surface Prep
Loose spores and dust get vacuumed off framing, joists and duct interiors with a ProTeam HEPA vacuum. We wipe heavy growth with an antimicrobial solution before fogging so the mist can reach the substrate instead of sitting on top of debris.
04
Thermal or Cold Fogging
We run a Dri-Eaz or Phoenix Restoration Equipment fogger with a Fiberlock or Benefect antimicrobial, matching droplet size to the space. A typical 1,000-square-foot home takes 45 to 90 minutes of fogging time. We fog in passes so every cavity gets full coverage.
05
Verification and Clearance
After a 2 to 4 hour dwell period, we run spore trap cassettes and compare counts to the outdoor baseline. If clearance passes, we remove containment and walk you through the results. If it doesn't, we re-fog at no extra charge.