01
Inspection and Testing
A certified technician walks the property with a moisture meter, thermal imaging camera, and boroscope inspection camera. We take air samples with a spore trap sampler and surface samples where growth is visible. You get the lab results and a written scope within 24 hours, usually the same afternoon.
02
Containment Setup
We seal the work zone with 6-mil containment plastic sheeting and zipper doors, then run a negative air machine with HEPA filters so spores cannot migrate into clean rooms. Technicians suit up in disposable coveralls, respirators, and personal protective equipment before any material is disturbed.
03
Removal and Cleaning
Porous materials like drywall, insulation, and carpet get bagged and hauled out. Solid framing gets HEPA vacuumed, then treated with an antimicrobial solution such as Benefect or Concrobium. For heavy growth on joists and subflooring we use dry ice blasting, which strips mold without water or harsh chemicals.
04
Drying and Sealing
Dri-Eaz and Phoenix Restoration Equipment dehumidifiers run until framing moisture drops below 16 percent on our meter. Once dry, we apply an encapsulant coating to lock down any residual staining. A fogger distributes a fine antimicrobial mist into wall cavities and ductwork that brushes cannot reach.
05
Clearance Testing
We take post-remediation air samples and compare them to the outdoor baseline. If spore counts are still elevated, we re-clean at no extra charge. You get the clearance report in writing, which is what landlords, buyers, and insurance carriers ask for.